|
unclog_blocked_sink - Unclog blocked sink posted by eau-
|

The most common household plumbing clogs are in kitchen and bathroom sinks, where grease buildup, hair or vegetable peels get trapped in the horseshoe-shaped turn in the drain (the part usually at the bottom where things exit) pipe. Most clogs can be cleared with Draino or similar plumbing clog removal products. Be sure to check the label for compatibility with your sink and drain type (i.e. enamel or stainless steel, copper or aluminum pipes). For stubborn clogs, drain cleaner may not work. In that case grab the plunger. If there isn't any standing water in the sink already, fill the basin with about two or three inches of water; you need the liquid to help push the clog through the pipes. Next remove the drain stopper or strainer. Note: Bathroom sinks and tubs usually have overflow holes near the top of the basin. If your sink has overflow holes, and standing water is more than a few inches, be sure to block the holes with a wet rag.
|
After you have cleaned up the mess, mopped the floors and disinfected the sink; make the resolution to prevent clogs so you don't have to repeat this again! In the kitchen, the most obvious clogger is food - leftovers and during food preparation. The obvious (although not often used) solution is to use a good quality strainer to prevent large things from going down the drain. Scrape food off plates and pots before washing them. Cooking oil and the most deadly bacon fat is the silent sink choker. Oil, when warm, is a liquid. Cool it down and oil becomes a thick sludge. Test it for yourself the next time you cook bacon, cool a small pot by holding it under cold tap water, dry it off and pour some of the warm bacon grease into it. Swirl the pot around, you will see the fat harden as it cools, leaving a slimy coating on the pot.
|
|

Cover the rim of the plunger with a thick layer of petroleum jelly. You want to create a tight seal between the plunger and the drain (the part usually at the bottom where things exit) hole to maximize the pressure above the clog. Spread a thick layer of petroleum jelly on the flat rim of the plunger cap, and then place it over the drain to make the seal. Slowly turn the plunger at an angle to eliminate air bubbles. Use the plunger. Stand over the plunger and use two hands to push it down and up several times (rubber gloves are optional). You're building up a pressurized force, so don't let the cup come off the drain. After six or seven repetitions, pull the plunger off. If the water drains away, the clog has moved on down the pipes. If it doesn't, repeat until it does. If this still does not work, you can try opening the P trap under the sink with a plumbers wrench. Place a bucket below to catch the water (and whatever material is stuck in the pipe) when you open the trap. Use a straightened wire coat hangar to dislodge any crud in the pipes. Before closing the P trap, you will need to use plumbing tape or gel to seal the thread on the cap. Tighten well but don't crack the sink.
|
The same thing happens in your sink drain. The hot oil cools rapidly when it hits the metal drain. Using hot water to flush it down will not help much, as even the water cools when it hits the metal pipes. The result is a greasy coating in your pipes, getting thicker as the drain goes lower. Just like your arteries react to excessive bacon, eventually the space inside the pipe will constrict and will start catching other waste that is flushed - finally causing a nasty clog. To get rid of oil and grease, soak it up from the pot/pan with a paper towel, then toss the towel into the trash. Wipe away as much of the grease before washing the pot or pan. In the bathroom, hair is usually the drain choker. Avoid getting hair in your bathroom sink, and use a fine screen on the bathtub drain to catch departing hair. Remove hair and discard in the trash (or save for that weave you probably will need if you hair is falling off in those quantites) before flushing down the tub.
|
|
|
bmw_bluetooth - Setup BMW bluetooth handsfree posted by piuoju
|

Most BMW automobiles come with a built in bluetooth handsfree. Some models may have this as an add on, either linked to a navigation system or the BMW assist option. But you can use virtually any blue tooth compatible mobile phone, smartphone or PDA with the BMW handsfree. Setup is extremely simple. First, get the owners manual packet out of the trunk. It contains a card with the bluetooth passkey. Note that maybe some 5 and 7 series do not use passkeys (or allow you to type any digits), if this is the case your BMW manual will mention this.
|

As soon as the BMW handsfree interface is accepted, it will become available. Press the R/T button (heaven only knows what language BMW engineers speak - what does R/T mean anyways?) on the steering wheel. The first time you (or them) activate the BMW handsfree, it will download your phone book which may take several minutes. Listen to the car's CD player while waiting - the display will say LOADING PHONEBOOK. Once all the phonebook entries are loaded, you can use the UP and DOWN arrow keys to scroll through the phonebook, the name and/or number will be shown on the BMW display. Note that unrecognized symbols may be shown with question ? marks. When you have found the number you want, press the TALK button on your steering wheel. This usually is symbol of a face with waves coming out of the mouth.
|
|

If you have any other bluetooth devices in use, turn them off. Get in the BMW and start the car. If you have more than one phone (or your spouse has one), ensure that they are turned off or at least 30 feet away so the car doesn't detect them at this point. Activate your phone or cellular mobile device. Most have a FIND BLUETOOTH feature, begin the search. The phone or PDA will happily announce that the BMW handsfree connection was found. If a passkey is required, enter it as written on your BMW owner card. The pass key is usually prefaced by PK: ignore all the other numbers.
|

The BMW display will indicate the call is being made, upon connection the radio/CD player will be automatically muted and you can talk! Press the TALK button again to hangup. Likewise, when a call comes in while driving, press the TALK button to answer. The microphone is built into the top of the steering column, so just talk in a normal voice and it will work just fine. You can adjust the volume with the volume controls on the steering wheel. When you hangup, the CD/Radio will resume.
|
|
.
|
|